Vertex Standardt VXD Series Guia de Instalação

Professional Digital two-way raDio systemVXD-R70 RepeaterInstallatIon GuIdeVertex Standard LMR, Inc.

Page 8Chapter 1 Pre-Installation ConsiderationsProper installation ensures the best possible performance and reliability of the VXD-R70 Repeater. Pre-

Page 91.3 Equipment VentilationThe repeater is equipped with a cooling fan that is used to provide forced convection cooling. When planning the insta

Page 101.6.3 Lightning GroundProviding adequate lightning protection is critical to a safe reliable communications site. RF trans-mission cables, and

Page 11Chapter 2 Mechanical InstallationChapter 2 Mechanical InstallationThis section describes the procedures to unpack and mechanically install the

Page 12Chapter 3 Indicators and Connectors3.1 Front PanelChapter 3 Indicators and Connectors3.1.1 LED Indicator DescriptionsLED Status DescriptionPO

Page 13Chapter 3 Indicators and Connectors3.2.1 Rear Panel Part3.2 Rear PanelNo Item DescriptionRx Connector BNC (Female).Power Supply On/Off Switch

Page 14Chapter 3 Indicators and Connectors3.2.2 Rear Accessory ConnectorThe rear accessory connector is located above the ethernet connector. Most of

Page 15Chapter 4 Electrical ConnectionsAfter the VXD-R70 Repeater has been mechanically installed, electrical connections must be made. This i

Page 164.1.2 Ground ConnectionThe repeater is equipped with a ground screw located on the rear of the repeater. Connect the site ground cable to the

Page 17Chapter 4 Electrical Connections4.2 RF Antenna ConnectionsThe transmit and receive antenna RF connection are made using two separate connector

table of Contents

Page 18Chapter 5 Post-Installation ChecklistAfter the VXD-R70 Repeater has been mechanically installed and all electrical connections have been made,

Page 19Warranty PolicyVertex Standard warrants, to the original purchaser only, its Vertex Standard manufactured communications products against defec

Page 20Note



Vertex Standard LMR, Inc.Copyright 2013Vertex Standard LMR, Inc.All rights reserved.No portion of this manualmay be reproducedwithout the permission o

Page 1ForewordThis manual is intended for use by experienced technicians familiar with similar types of equipment. Speci-cally, it contains installat

Page 2Installation Requirements for Compliance withRadio Frequency (RF) Energy Exposure SafetyStandardsATTENTION!This radio is intended for use in o

Page 3Declaration of ConformityThis declaration is applicable to your radio only if your radio is labeled with the FCC logo shown be-low.DECLARATION O

Page 4ATTENTION!BEFORE USING THIS RADIO, READ THIS CHAPTER WHICH CONTAINS IMPORTANT OPER-ATING INSTRUCTIONS FOR SAFE USAGE AND RF ENERGY AWARENES

Page 5Your Vertex Standard two-way radio complies with the following RF energy exposure standards and guidelines: United States Federal Communicatio

Page 6NOTE: If you are not sure of the rated power of your radio, contact your Vertex Standard representative or dealer and supply the radio model

Page 7FacilitiesTo avoid electromagnetic interference and/or compatibility conicts, turn off your radio in any facility where posted notices instr